Control method of impact sound of NSK rolling bearings

The control method of the impact sound of NSK rolling bearings is to appropriately reduce the radial clearance, use a bearing with a reasonable structure and a suitable material cage.

The second is the rolling sound of NSK rolling mill bearings and its control method. Rolling sound refers to the smooth and continuous sound produced by rolling elements rolling on the raceway surface when the bearing is running. It is a unique basic sound that appears in all NSK bearings. sound. The general azimuth sound is the raceway sound plus other sounds. The greater the rigidity of the bearing box, the lower the sound pressure level of the raceway sound. If the radial gap is too small, as the radial gap decreases, the sound pressure level and main frequency of the sound channel will increase sharply.

The way to control the sound of the raceway is to select low-noise bearings, that is, bearings with very low waviness, and carefully choose the conditions of use. The sound of the raceway usually affects the noise of the entire machine. Reducing the sound of the raceway can reduce the noise of the entire machine.

Finally, the rolling sound of the imported bearings of the rolling mill and its control method. Rolling sound is the violent metal friction sound that may occur in cylindrical roller bearings under any circumstances. Most of them appear in larger bearings that use grease lubrication, and base oils are more likely to occur during grease lubrication and hardly deteriorate grease. In addition, it is more likely to occur in winter. When it bears pure radial load, it is easy to happen when the radial clearance is large, and according to the size of the model, it is easy to happen in a specific speed range, and it will happen continuously. Will appear intermittently. The outer ring raceway adopts a special processing method to prevent rolling noise. If necessary, you can use this bearing,

However, sometimes due to the incorrect measurement of the shaft diameter and bearing hole size of the rolling mill or the roughness of the mating surface does not meet the standard requirements, the interference fit is caused, and the bearing ring is severely squeezed, resulting in the reduced clearance of the radial bearing itself. FAG bearings are difficult to rotate, generate heat, increase wear or seize, and in severe cases, the inner and outer rings of the bearing may be broken during the installation process.

Inquiry us